coilover install

[spooln2004]

where can i get my coilover installed and do you know about how much the caust to have them installed

[Speed JUnkyz]

Welll holy shit mang! Look who decided to come out of the closet!!! HAHA


Post picks of these badasses.....and Ill answer your question. ;)

[spooln2004]

yeah i am back gti is sold it got 342whp 302tq on the dyno now time for a new house and new parts for evo

[Speed JUnkyz]

Whats wrong with your house? HAHA

[dj_darkhorse7727]

are you still lookin for a place to get the install? if so let me know i have a shop in new oxford if your local. hit me up if your interested.

[Speed JUnkyz]

He is from Manhiem. About an hour out depending on traffic.

Fritz this guy is cool. I met him ;) I can vouch for him HAHA

[JONPKA24]

coil overs arent hard to install, make them the hight you want, tn bolt them up like your factory struts/springs

[Speed JUnkyz]

Hey Joe wheres your shop at?

[dj_darkhorse7727]

IN NEW OXFORD ABOUT 4 BLOCKS FROM THE SQUARE OFF OF A BACK ALLY. IF ANY ONE NEED DIRECTIONS LET ME KNOW.

[91240kat]

Coilovers are not hard , except it really helps if you have an impact wrench. ohh and a place out of the cold ......

[Boo-Rad]

Just do it yourself bro. If i can do im sure you can. Im what you call mechanically inclined...

[Speed JUnkyz]

Yeah but fritz is the type to buy and then have someone else install... He used to own a VW ;) :lol:

[Speed JUnkyz]

Yeah Joe Ill take more accurate directions...Just post it up if you don't mind, if you want it more private than PM it to me

[dj_darkhorse7727]

to make this as general as possible


make your way to rt 30 (york rd)

head to new oxford (between york and gettysburg)

from new oxford square head east towards york/cross keys and make a right on college st (forth right i think) and look for the tan pole building on your right thats us



if you would like to come and hang out for a while or want to set up an appointment please call first (im constantly runnin everywhere) 717 817 3573

[greatgonzer]

Ok your shop is a bit out of my way (ALbuquerque, NM) so I'm going to attempt this myself in my EVO. I've done them before and its quite easy!!!! Just unbolt (ususally 6 bolts, use spring compressor, remove end nut with impact wrench, put in new springs, cut bump stop down. bolt back up your done. Coilovers are even easier as no spring compressor is needed. This is one of the easiest modification one can do. Getting the car aligned after that though requires a shop.

[Speed JUnkyz]

I guess if they come complete with strut assembly and all its even easier? Just an easy remove and install?

Will you need an alignment still if it did come complete? I always wondered why you need to align after.

[greatgonzer]

Ok, SPEED JUnkyz, I have to tell you right now that your AVATAR is unfair! you MUST show us the rest of that picture w/o cutting out the good parts. You know my email address :)

[Speed JUnkyz]

Ok, SPEED JUnkyz, I have to tell you right now that your AVATAR is unfair! you MUST show us the rest of that picture w/o cutting out the good parts. You know my email address :)


LMAO......Ok ill send it But you have to hold ur breath until you get it. Im sending right now, don't forget to hold ur breath